Back to Blog
We have added cuts and extrudes to make different geometries out of the same original geometry to create different parts. This is the same geometry as other K’NEX pieces, but with slightly more than necessary. Here is a standard K’NEX piece with eight openings. In part two, we will discuss how to configure a K’NEX assembly and how to use tools like DriveWorks to create configurations. Today we will discuss how to manually configure K’NEX connectors and then how to use a design table in SOLIDWORKS to configure K’NEX rods. This is the first in a series of two blogs based on configurations modeled by K’NEX. In this blog, we will use K’NEX pieces to demonstrate this process. Have you ever needed to create a series of parts that were similar but slightly different in a few features, dimensions, colors, etc? In SOLIDWORKS, you can easily create a part then configure it to the exact specifications necessary for the other parts without the tedious recreation process.
0 Comments
Read More
Leave a Reply. |